EK’s HD 7970 water block is the top performer

Overclocking the graphics card from factory set 925/1375MHz to 1125/1500MHz (GPU/RAM respectively) and Vgpu set at 1.250V – the limit of our overclocking software – yielded similiar result:

Tgpumax = 42°C

Th2omax = 31.1°C

dTmax = 9.9°C = ~ 10°C

Where Tgpumax is the highest temperature of the GPU core, logged by software; Th2omax is the highest temperature of the coolant measured by thermometer; dTmax is the highest delta (difference) between the GPU core temperature and the coolant temperature – lower is better.

Please note that the smallest resolution for Tgpu probe is 1°C therefore a rounding error is present. Considering this fact we can see that dT does not increase even at overclocked conditions. Also the VRM (voltage regulation module) is noticably cooler than we are used to. The hottest measured temperature was ~ 49°C (behind the MOSFETs, on the back side of the PCB), highest logged temperature was 50°C after almost 5 hours of Furmark. 

The best thing about the block is certainly the extremelly low flow resistance with it’s figure much closer to those of radiators than high performance water blocks. It surpases our flagship CPU waterblock EK-Supreme HF by a large margin. You can easily run four of these cards on one medium performance water pump! Picture below shows the hydraulic curve:

 The EK-FC7970 water block – which will come in all four versions (Copper Plexi, Copper Acetal, EN Nickel Plexi, EN Nickel Acetal) will be available for purchase through EK Webshop by the end of next week. The matching FC Backplate is also in the works and will be available in the following weeks.

Source