Thermaltake Urban S71 Chassis Review

The chassis interior features the same high quality paint job as the exterior, giving the whole chassis a really nice uniform appearance. There is a good size CPU cooler cut-out, as well as five cable routing holes with rubber grommets, there are also some small cable routing holes on the top right without grommets should you need them.

Each of the top three 5.25″ bays feature a quick release clip while the fourth features an adaptor bracket that would be suitable for a card reader or similar compact device. The five hard drive trays below that all support 3.5″ and 2.5″ drives.

The rear of the chassis features a good quality 120mm exhaust fan which comes with a sheathed black cable, keeping nicely with the slick all black design of the chassis. The expansion slot covers are all reusable and feature quick release thumb screws for easy installation.

The bottom air filter will provide airflow to both the PSU and a 120/140mm fan (optional).

The top of the chassis features a pre-installed 200mm low RPM exhaust fan, but you can mount a pair of 120mm or 140mm fans here, or even a water cooling radiator.

Around the back there are lots of cable tie loops, more than you normally see on a chassis of this size and this should help keep any excess cable in check, making for a very tidy looking buildd.