These results measure the power supply from 0% load to 100% load on various rails to simulate a power spike from your system. Typically, we would like to see as small a spike as possible relative to the requested voltage. With modern GPUs being notorious for power spikes, this is becoming more relevant in modern PSU design.
The specifications for ATX 3.0 were released in February 2022. It includes the new 16-Pin 12vHPWR connector that can deliver up to 600 W to graphics cards. These incorporate data lines for components to negotiate power capabilities with the PSU so they do not draw more power than the PSU is capable of delivering. The specification also has more strict requirements for handling spikes, two times the nominal output for 100 microseconds.
Linear, clean and accurate transients are what we like to see, and again, this PSU just hit its mark every time in the transient testing, with no over or undershoot and a very quick load time response.
💪 Resilient Against the Elements: Crafted with water and dirt-resistant materials, including natural rubber and…
【Better Heat Dissipation】The CPU cooler comes with 4 direct-contact heat pipes and a 120mm FDB…
【Stability is very good】 Non-slip rubber material base that provides heavy grip preventing sliding or…
The elegant design of the ASSASSIN IV WH is not just visually pleasing; it also…
8,000 DPI gaming-grade sensor responds precisely to movements: Customise your sensitivity settings to suit the…
【24.5'' FHD Gaming Monitor】24.5 inch (1920 x 1080P) VA monitor with 3-sided ultra-thin bezel design,…
