Crucial MX200 1TB Solid State Drive Review

Test Procedure

Test system:

• Supermicro C7Z97-OCE
• Intel Xeon E3-1230Lv3
• Corsair Vengeance 8GB 1866MHz
• Corsair H100i
• BeQuiet Dark Power Pro 850W
• Kingston HyperX 240GB SSD

Software used:

• Aida64
• Anvil’s Storage Utilities 1.1.0
• AS SSD Benchmark 1.7.4739
• ATTO Benchmark 2.46
• CrystalDiskMark 3.0.3

In a bid to make our testing as thorough and as accurate as possible, we have devised a testing methodology to give us the maximum amount of data. Whilst this means that testing each drive will take considerably longer to test – nearly 36 hours in fact, the picture that we are able to build upon the overall performance of each drive is far clearer, providing a more accurate analysis at how a drive performs under different conditions.

I will be testing the drives performance when it is clean and fresh out of the box and then start to fill it up with data, namely 25%, 50% and 75% of the drives capacity and rerun the tests under each of these scenarios. I’ll be using the same sample files under each test to keep the results as consistent as possible. The files in question are a collection of files from my personal NAS, composed of a mixture of small and big files, media, programs, and archives.

On top of this, I will also take the wear on the NAND into consideration and this process obviously takes a long time to perform – so long under real world conditions that it is simply not practical. In order to accelerate this conditioning process I will use the SSD endurance test that lies within Anvils Storage Utilities and read / write 15TB of data to the drive through a process of filling the drive with thousands of small files of various sizes and compressibility (with randomised duration between each of the writes), then reading each of them back with a randomised time between each file. After this has completed, the data is then erased and the process starts again. This process of conditioning the drive can take anywhere upwards of 12-15 hours on a typical 256GB SATA III SSD, however, the performance and capacity of the drive will influence the time it takes to condition the drive.

Following the conditioning process, the benchmarking process described above is repeated again with the volume filled with the same sample data to each percentage between test runs. Furthermore between each benchmark, the drive will get a TRIM command sent and further left alone for a while to make sure the TRIM command has done its job. TRIM can heavily impact a drives performance as it takes place, so allowing a period of time between tests will eliminate this factor and any subsequent false performance figures.

On each page that follows with the benchmark results, I have inserted the screenshots from the benchmark results, created a drive analysis chart for fill-level as well as a drive comparison chart for each software used.